Table of Contents
Advertisement
4?
,,~ Tilt-Lock (stand-up) Units
$2
,:)
...
.
Tilt-Lock units cannot be
removed.
You can lift a tilt-lock unit upward
about 6 inches and it will lock in
the up position.
To reposition the tilt-lock unit:
Replace the drip pan then the
trim ring into the recess in
the cooktop.
Put the trim ring in place over the
drip pan. The drip pan must be
under the trim ring.
Guide the surface unit into place
so it fits evenly into the trim ring.
Plug-In Units
(On models so equipped)
Plug-in units can be removed.
Lift a plug-in unit about 1 inch
above the trim ring—just enough
to grasp it—and pull it out.
Do not lift a plug-in unit more
than 1 inch. If you do, it may not
lie flat on the trim ring when you
plug it back in.
"
Repeated lifting of the plug-in
unit more than 1 inch above the
trim ring can permanently
damage the receptacle.
To replace a plug-in unit:
Replace the drip pan into the
recess in the cooktop. Make sure
opening in pan lines up with
receptacle. If you have separate
trim ring, put it in place over the
drip pan. The drip pan must be
under the trim ring.
Separate
Drip Pan & Trim Ring
installation/Removal~
Re
Insert the terminals of the plug-in
unit through the opening in the
drip pan and into the receptacle.
c Guide the surface unit into place
so it rests evenly.
Note: The drip pan must be under
the trim ring.
CAUTION
Do not attempt to clean plug-in
surface units in an automatic
dishwasher.
QDo not immerse plug-in surface
units in liquids of any kind.
Do not bend the plug-in surface
unit plug terminals.
. Do not attempt to clean, adjust or
in any way repair the plug-in
receptacle.
Adjusting Oven Thermostat
Use time given on recipe when
cooking the first time. Oven
thermostats, in time, may "drift"
from the factory setting and
differences in timing between an
old and a new oven of 5 to 10
minutes are not unusual. If you
find that your foods consistently
brown too little or too much, you
may make a simple adjustment in
the thermostat (Oven Temp) knob.
Pull knob off of shaft, look at back
of knob and note current setting
before making any adjustment.
To increase temperature, turn
toward HI; to decrease turn toward
LO. Each notch changes temperature
10 degrees.
1. Pull off knob. Loosen both
screws on back of knob.
2. Move pointer one notch in
desired direction. Tighten screws.
3. Return knob to range, matching
t-at area of knob to shaft. Recheck
oven performance before making
an additional adjustment.
21
Advertisement
Table of Contents
