Receiving Traffic Announcements; Tuning Into Alternative Frequencies - Pioneer AVIC-F320BT Operation Manual

Using the radio (TUNER)
4 Press the centre of MULTI-CONTROL to
begin a search.
The tuner searches for a station broadcasting
that programme type.
p To stop the search, press the centre of
MULTI-CONTROL.
p The programmes of some stations may dif-
fer from that indicated by the transmitted
PTY.
p If no station is broadcasting the type of pro-
gramme you searched for, "Not Found" is
displayed for about two seconds and then
the tuner returns to the original station.
Receiving traffic
announcements
TA (traffic announcement standby) lets you re-
ceive traffic announcements automatically, no
matter what source you are listening to. TA
can be activated for both a TP station (a sta-
tion that broadcasts traffic information) or an-
other enhanced network's TP station (a station
carrying information that cross-references TP
stations).
1 Tune in a TP station or another en-
hanced network's TP station.
When you are tuned into a TP station or an-
other enhanced network's TP station,
indicator will light.
Display the "Function Menu" screen.
2
= For details of the operation, refer to Display-
ing the "Function Menu" screen on page
79.
3 Turn MULTI-CONTROL to display
"Traffic Announce".
4 Press the centre of MULTI-CONTROL to
switch the setting to "On".
Each press of the centre of MULTI-CONTROL
switches the setting between on and off.
p You can also cancel the announcement by
changing the audio source or pressing
MULTI-CONTROL left or right.
5 Use MULTI-CONTROL to adjust the TA
volume when a traffic announcement be-
gins.
The newly set volume is stored in memory and
recalled for subsequent traffic announce-
ments.
6 Press the BAND/ESC button while a
traffic announcement is being received to
cancel the announcement.
The tuner returns to the original source but re-
mains in standby mode until turning the traffic
announcement standby off.
p Pressing the SRC/OFF button enables you
to perform the equivalent operation.
p The system switches back to the original
source following traffic announcement re-
ception.
p Only TP stations and other enhanced net-
works' TP stations are tuned in during seek
tuning or BSM when the TA function is
on.
Tuning into alternative
frequencies
If you are listening to a broadcast and the re-
ception becomes weak or there are other pro-
blems, the navigation system will
automatically search for a different station in
the same network that is broadcasting a stron-
ger signal.
Display the "Function Menu" screen.
1
= For details of the operation, refer to Display-
ing the "Function Menu" screen on page
79.
2 Turn MULTI-CONTROL to display
"Alternative FREQ".
3 Press the centre of MULTI-CONTROL to
switch the setting to "On".
Each press of the centre of MULTI-CONTROL
switches the setting between on and off.
Chapter
16
83
Engb