Enhancing Bass (Bass Booster); Using The High Pass Filter; Adjusting Source Levels - Pioneer AVIC-F320BT Operation Manual

Gps navigation audio system
Hide thumbs Also See for AVIC-F320BT:
Table of Contents

Advertisement

Chapter
22
Customising preferences

Enhancing bass (Bass Booster)

You can enhance bass sounds that are often
muted by driving noise.
Display the "Audio Menu" screen.
1
= For details, refer to Displaying the
"Audio Menu" screen on page 116.
Turn MULTI-CONTROL to select "Bass
2
Booster".
3
Press MULTI-CONTROL up or down to
select a desired level.
"0" to "+6" is displayed as the level is in-
creased or decreased.

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, activate HPF
(high pass filter). Only frequencies higher than
those in the selected range are output from
the front or rear speakers.
Display the "Audio Menu" screen.
1
= For details, refer to Displaying the
"Audio Menu" screen on page 116.
Turn MULTI-CONTROL to select "HPF".
2
3
Press the centre of MULTI-CONTROL to
turn high pass filter on.
p To turn high pass filter off, press
MULTI-CONTROL again.
4
Press MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pressed left or
right, frequencies are selected in the following
order:
50 Hz — 63 Hz — 80 Hz — 100 Hz —
125 Hz
120
Engb

Adjusting source levels

SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
p Settings are based on the FM tuner volume
level, which remains unchanged.
1
Compare the FM tuner volume level
with the level of the source you wish to ad-
just.
Display the "Audio Menu" screen.
2
= For details, refer to Displaying the
"Audio Menu" screen on page 116.
Turn MULTI-CONTROL to select "SLA".
3
4
Press MULTI-CONTROL up or down to
adjust the source volume.
Each time MULTI-CONTROL is pressed up or
down, source volume increases or decreases.
"+4" to "-4" is displayed as the source volume
is increased or decreased.
p The different source volume level can be set
between iPod and USB.
p The source volume level for MW/LW can be
set separately from FM.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Avic-f3210bt

Table of Contents