GE JAS02M Use And Care & Installation Manual page 21

Anti-Tip Device Installation Instructions
for Device Kit No. WBO6XO1O3
I
I
DEVICE PACKED WITH
RANGE
SEE INSTRUCTIONS
Tools Needed
Phillips head screwdriver
Flat blade screwdriver
Device attaches to floor or wall to
hold either right or left rear leg
leveler. If fas~ening to floor, b= sure
that screws do not penetrate
electrical wiring or plumbing. If
this cannot be determined, use
shorter screws that will not
penetrate through flooring.
Attachment
to wall
Fig. 2
—
. — —— —
1. Decide whether the device will
be installed on the right or left side
of range location.
2. If the device side of the range
is adjacent to a cabinet, place the
device against back wall and
cabinet as shown in figure 1.
If there is no adjacent cabinet,
determine where the location of the
range side (painted outside panel)
will be. Place the device with its
outside edge at this location and
against back wall. See figure 1.
21
Wall behind range
Wall plate
--
3. Determine whether you will
anchor the device to the floor or
to the wall as shown in figure 2.
For greater stability fasten the
device to both the wall and the
floor if possible. Fasten the device
securely with the screws provided.
Screws are self-drilling in wood,
plywood, particle and chip board,
and most metal framing. If attaching
to masonry you can b~y suitable
screws and anchors at hardware
stores. Use a masonry drill to drill
the required holes.
4. Using the wrench, back out the
four leg levelers at least two turns.
See your installation guide for
more leveling information before
positioning range.
5. Slide the range into place.
.-
-