Installation Using The Screw Holes On The Side Of The Unit - Pioneer FH-P80BT Installation Manual

Installation
2. Install this unit and fasten the screws.
Dashboard
Screw (3 × 6 mm)
3. Attach the trim ring.
Trim ring
Installation using the screw
holes on the side of the unit
1. Remove the side brackets.
Rubber bush
Double-ended screw
Side bracket
Screw for fixing the side
bracket (5 × 8 mm)
2. Fastening the unit to the factory
radio-mounting bracket.
Position the unit so that its screw holes are
aligned with the screw holes of the bracket,
and tighten the screws at 3 or 4 locations on
each side.
If the pawl gets in the way,
bend it down.
Factory radio
mounting bracket
Binding screw or
flush surface screw
Be sure to use the
screws supplied
with this unit.
Note
In some types of vehicles, discrepancy may
occur between the unit and the dashboard. If this
happens, use the supplied frame to fill the gap.
Dashboard or console
9