Removing The Unit; Din Rear-Mount; Fastening The Front Panel - Pioneer DEH-P7900UB Operation Manual

MAN-DEH-P7900UB-GB.fm Page 4 Wednesday, February 21, 2007 11:20 AM
Installation
1. Insert the mounting sleeve into the dashboard.
• When installing in a shallow space, use a supplied mounting sleeve. If there is
enough space behind the unit, use factory supplied mounting sleeve.
2. Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°)
into place.
3. Install the unit as illustrated.

Removing the Unit

1. Extend top and bottom of the trim ring outwards to remove the trim ring. When
reattaching the trim ring, push the trim ring onto the unit until it clicks. (If the
trim ring is attached upside down, the trim ring will not fit properly.)
• It becomes easy to remove the trim ring if the front panel is released.
Trim ring
2. Insert the supplied extraction keys into both sides of the unit until they click into
place.
3. Pull the unit out of the dashboard.

DIN Rear-mount

1. Extend top and bottom of the trim ring outwards
to remove the trim ring. When reattaching the trim
ring, push the trim ring onto the unit until it
clicks. (If the trim ring is attached upside down,
the trim ring will not fit properly.)
• It becomes easy to remove the trim ring if the front
panel is released.
2. Determine the appropriate position where the
holes on the bracket and the side of the unit
match.
3. Tighten two screws on each side.
• Use either truss screws (5 mm x 8 mm) or flush
surface screws (5 mm x 9 mm), depending on the
shape of screw holes in the bracket.
Screw
Dashboard or Console
Factory radio mounting bracket

Fastening the front panel

If you do not plan to detach the front panel, the front panel can be fastened with
supplied screw.
Screw
4
Trim ring