Philips HFL3008D/W User Manual page 17

To view the hotel information screen by
INFO, in the professional setup
pressing
menu, select [Hotel information] > [Info
key enable] > [On].
Change professional mode settings
Professional mode settings
Use professional-mode settings to speed up
installation of your TV for commercial use.
1. In the professional setup menu, select
[Professional Settings], then press OK.
2. Select a setting to change, then press OK:

[Room ID]: Set a Room ID for the TV.

[Consumer setup]: Shortcut to the full
TV menu to configure all the TV
settings.

[Channel setup]: Shortcut to channel
list where you can re-arrange, rename
and hide channels.

[USB to TV]: Clone settings stored on
a USB storage device from another
Philips TV to your TV.

[TV to USB]: Copy your TV's settings
to a USB storage device. These settings
can be cloned onto another Philips TV.

[RF to TV]: Copy settings from a Philips
TV using RF signal.

[Reset]: Reset all professional mode
settings to the factory default.
Installation settings
Use these settings to configure installation
settings.
1. In the professional setup menu, select
[Installation].
2. Select a setting to change, then press OK:

[Blank channel]: Select a channel to
play audio only.

[Auto channel update]: Update
channels automatically.

[Auto software update]: Update your
TV software automatically.

[Skip scrambled signals]: Enable or
disable scrambled channels in the
channel list.

[Multi remote control]: Select an
option to identify a paired remote
control.

[MyChoice]: Enable or disable
MyChoice channels.

[ThemeTV]: Enable or disable Theme
TV.

[SmartPay]: Enable or disable SmartPay.
Pairing TVs with a remote control
You can pair a TV with up to ten remote
controls.
1. In the professional setup menu, select
[Installation] > [Multi remote control].
2. Select an option from [TV0] to [TV9] to
identify the paired remote control, then
press OK.
3. To set the remote control in a specific
mode, simultaneously press
key for 5 seconds to set the remote control
in the [TV0] to [TV9] mode.
Note:

Press and hold OK on a remote
control for more than five seconds. The
TV displays the TV ID (for example,
[TV0]) as well as the ID of the
transmitting remote control.

If the batteries in the remote control
are replaced after pairing, you will need
to pair the remote control with your
TV again to assign an ID to your TV.
Power-on settings
Customise the way the TV behaves when it
is switched on.
1. In the professional setup menu, select
[Switch on setting].
2. Select a setting to change, then press OK:

[Switch on channel]: Select a channel
to display when the TV is switched on.

[Switch on vol]: Select the volume of
the speakers to be used when the TV is
switched on.

[Max volume]: Limit the maximum
volume of the TV.

[Switch on picture format]: Select a
picture format to be used when the TV
is switched on. If the source does not
support the pre-defined format, [Auto
fill] is enabled.

[Power on]: Select the mode to be
used when the TV is switched on:
- [On]: If the mains power is switched
on, the TV automatically switches on.
- [Standby]: If the mains power is
and a number
EN 17