Selecting A Location And Connecting Input Power - MAC TOOLS MW 270 Plus Owner's Manual

3-13. Selecting A Location And Connecting Input Power

18 in (457 mm) of
space for airflow
Y Do not move or operate
unitwhere it could tip.
1
8
10
7
9
L1
L2
5
6
2
1
4
3
L2
Y Installation must meet all Na-
Y Special installation may be
Y Disconnect and lockout/tag-
=GND/PE Earth Ground
Y Always connect green or
1
Supply correct input power.
2
3
Connect plug to receptacle.
4
4
5
6
7
8
9
Connect green or green/yellow
grounding conductor to disconnect
device grounding terminal first.
Connect input conductors L1 and
L2 to disconnect device line termi-
nals.
10 Over-Current Protection
Select type and size of over-current
protection using Section 3-12
(fused disconnect switch shown).
Close and secure door on discon-
nect device. Remove lockout/tag-
out device, and place switch in the
On position.
L1
230 VAC, 1
tional and Local Codes −
have only qualified persons
make this installation.
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
out input power before con-
necting input conductors
from unit.
green/yellow conductor to
supply grounding terminal
first, and never to a line ter-
minal.
Rating Label
Plug
Receptacle
Black And White Input
Conductor (L1 And L2)
Green Or Green/Yellow
Grounding Conductor
Input Power Cord.
Disconnect Device (switch
shown in the OFF position)
Disconnect Device Grounding
Terminal
Disconnect Device Line
Terminals
803 766-B / 802 286-E
OM-219 806 Page 17