Connecting Input Power - MAC TOOLS MW50 Owner's Manual

3-7. Connecting Input Power

1
3
2
6
For Plug Connection
OM-154 501 Page 10
3 4 3
1
Tools Needed:
5
4 3
ssb2.2 12/94 − Ref. ST-154 619-B / Ref. ST-149 405-B
Have only qualified persons make
this installation.
1 Line Disconnect Device Of
Proper Rating
2 230 Volts AC Wall Receptacle
3 Input Conductors
4 Grounding Conductor
Select size and length using 3-5.
Conductor rating must comply with
national, state, and local electrical
codes.
Install and connect grounding
conductor and input conductors in
conduit or equivalent between wall
receptacle and deenergized line
disconnect device.
Connect grounding conductor first,
then line input conductors.
Be sure grounding conductor goes
to an earth ground.
5 Overcurrent Protection
Select type and size using 3-5.
Install into deenergized line discon-
nect device (fused disconnect
switch shown).
6 Input Power Plug
Turn off unit Power switch, and con-
nect plug to wall receptacle.