Installing Wire Guides And Drive Rolls - Miller Electric SWLR-115 Owner's Manual

2-5. Installing Wire Guide And Drive Rolls
6
7
Tools Needed:
5/64 in
5
8
9
2
4
.
1
Close spring shaft carrier.
2
3
Turn nuts one click to line up lobes
with lobes on drive roll carriers.
Open spring shaft carrier.
4
Remove drive rolls.
5
Loosen wire guide screws.
6
7
Install inlet wire guide into anti-wear
guide, and secure with setscrew.
Install inlet guide so groove is cen-
tered with screw, and secure guide
screw. Do not push inlet guide into
drive roll.
8
Insert intermediate guide until
flange on guide rests against cast-
ing, and secure guide screw.
Install drive rolls, and turn nuts one
click.
9
Close cover.
1
3
When changing wire size or
type, check drive roll size (see
Table 5-1).
Spring Shaft Carrier
Drive Roll Nut
Drive Roll Carrier
Drive Roll
Wire Guide Securing Screw
Anti-Wear Guide
Inlet Wire Guide
Intermediate Wire Guide
Drive Assembly Cover
ST-153 125-B / Ref. SC-150 922
OM-1597 Page 11