Get Started; Connect Speakers; Connect Fm Antenna; Connect Control Cable - Philips MCM772 User Manual

3 Get started

Caution
•
Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial numbers. Find the model
number and serial number of this audio system
at the back or the bottom of your audio system.
Write these numbers here:
Model No. __________________________
Serial No. ___________________________

Connect speakers

Note
•
Insert the stripped portion of each speaker wire into
the socket completely.
•
For optimal sound, use the supplied speakers only.
•
Connect only speakers with impedance that is the same
or higher than the supplied speakers (see 'Specifi cations'
on page 22 ) .
1
Insert fully the red end of the speaker
cable into the red (+) socket on the main
unit.
2
Insert fully the silver end of the speaker
cable into the black (-) socket on the main
unit..
12 EN
3
Repeat steps 1-2 for the other speaker
cable.
4
Repeat steps 1 to 3 to connect the other
speaker.

Connect FM antenna

Tip
•
For optimal reception, fully extend and adjust the
position of the antenna.
•
For better FM stereo reception, connect an outdoor
FM antenna to the FM ANTENNA jack.
•
The audio system does not support MW radio
reception.
1
Connect the supplied FM antenna to the
FM ANTENNA jack on the main unit.

Connect control cable

1
Connect the control cable between the
player and amplifi er.