Sip Settings - Nokia N93i-1 User Manual

WEP key settings—Enter
key), WEP key format (ASCII
key (the WEP key data in the selected format).
Security settings for
follows:
WPA mode—Select the means of authentication:
use an extensible authentication protocol (EAP) plug-in or
Pre-shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings
your service provider instructs.
Pre-shared key (only for
password. The same password must be entered on the
wireless LAN access point device.
TKIP encryption—Select whether Temporal Key Integrity
Protocol (TKIP) is used.
Homepage—Define a home page.
Select Options > Advanced settings
following:
IPv4 settings: Phone IP address
device), Subnet mask
gateway (the gateway), and
addresses of the primary and secondary DNS server.
Contact your internet service provider for these addresses.
116
WEP encryption (length of the
or Hexadecimal), and
802.1x and WPA/WPA2 are as
(only for EAP)—Enter the settings as
Pre-shared key)—Enter a
and from the
(the IP address of your
(the subnet IP address), Default
DNS address—Enter the IP
IPv6 settings >
WEP Well-known, or
Ad-hoc channel
number (1-11) manually, select
Proxy serv. address—Enter the address for the proxy
EAP to server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data conn.—If you select
are in a network that supports packet data, the device
registers to the packet data network. Starting an active
packet data connection is quicker. If there is no packet
data coverage, the device periodically tries to establish a
packet data connection. If you select
device uses a packet data connection only if you start an
application or action that needs it.
Access point—The access point name is needed to use your
device as a packet data modem to your computer.

SIP settings

SIP (Session Initiation Protocol) settings are needed for
certain network services using SIP, such as video sharing.
DNS address—Select Automatic,
User defined.
(only for Ad-hoc)—To enter a channel
User defined.
When available
When
and you
needed, the