GE JKS10DP Dimensions And Installation Information

JKS10DP
GE 27" Built-In Single Wall Oven
®
Dimensions and Installation Information (in inches)
KW Rating
240V
3.4
208V 2.6
Breaker Size
240V 20 Amps
208V
20 Amps
Note: These ovens are not approved for stackable or
side-by-side installations.
Note: These ovens can be installed side-by-side with no less
than 30" distance between center-to-center of each oven.
Note: Cabinets installed adjacent to wall ovens must have
an adhesion spec of at least a 194°F temperature rating.
Note: For 27" built-in single ovens, if marks, blemishes or
the cutout opening is visible above the installed oven, it
10
may be necessary to add wood shims under the runners
A
Allow 3/4"
and front trim until the marks or openings are covered.
for overlap
over all edges
Note: Door handle protrudes 3" from door face. Cabinets
of cutout
and drawers on adjacent 45° and 90° walls should be
placed to avoid interference with the handle.
Electric wall ovens are not approved for installation
with a plug and receptacle. They must be hard wired in
accordance with installation instructions.
Installation Information: Before installing, consult
D
installation instructions packed with product for current
dimensional data.
32-1/2
E
For answers to your Monogram, GE Profile
®
C MIN.
GE ® appliance questions, visit our website at
ge.com or call GE Answer Center Conduit 48-1/2" long
2" x 4" ®
or equiv.
800.626.2000.
runners
B MIN.
Suitable
G
bracing
to support
runners
F
or
™
service,
2" x 4" or
C L
equivalent
runners
18"
Over centerline
of cabinet
(must support 275 lbs.)
Cabinet 27"
A – Cabinet width required 27" min.
B – Minimum cabinet depth 23-5/8"
C – Opening width 25" min. - 25-1/4" max
D – Opening height 27-5/8" min. - 28-1/8" max.
Oven
E – Overall depth* 23-5/8"
F – Overall height with trim 29-7/8" - 30-3/4"
Overall height without trim 29"
G – Overall width 26-5/8"
*Depth including door handle is approximately 26-7/10" min. to
26-8/10" max.
10
A
Locate
junction box
either 5" MIN.
below cutout
floor or 44"
MIN. above
cutout floor
Access
from
D
adjacent
cabinet
required
Minimum
cutout location
32-1/2
from floor
C MIN.
(Minimum 15-5/8"
Conduit 48-1/2" long
from floor when 2" x 4"
installed below built-in
or equiv.
microwave oven) runners
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Specification Created 5/09
Allow 3/4"
for overlap
over all edges
of cutout
B MIN.
G
to suppor
F
E
Listed by
Underwriters
Laboratories
320433
Suitable
bracing
runners