AWA W1090 User Manual page 47

DF-Q7412D-JS/H 2006.3.15 3:38 PM
• The Timer indicator lights on the front panel display when the DVD Recorder+VCR is ready for the Timer
Recording.
• The DVD Recorder+VCR will automatically power off when the Timer Recording ends.
• There is a short delay when a timer recording finishes to confirm the recorded program. If two timer recordings
are set to record sequentially (one right after the other), the very beginning of the later program may not be
recorded.
Timer Recording using G-Code system
Thanks to this programming system, you no longer need to tediously enter the date, programme number, start
and end time. All the information needed by the DVD Recorder+VCR for programming is contained in the G-Code
programming number. This G-Code number is found in most TV listings.
1
Insert recordable media such as DVD±R ,DVD±RW, recordable VHS tape.
2
Press [TIMER].
Press [SETUP] and select 'Timer REC'. Then press [ENTER].
or
The 'Timer Recording' menu appears.
3
Select 'G-Code' with [.../†] and confirm with [ENTER].
The 'G-Code' menu appears.
Enter the entire 'G-Code' number. This number is up to 9 digits long and
can be found next to the start time of the TV programme in your TV listings
magazine.
e.g.: 5-234-89 or 5 234 89
Enter 523489 for the 'G-Code' number.
4
Press [ENTER] to confirm.
5
The decoded information appears after confirmation. You can change the
information by selecting the appropriate input field using [...†]. If
required, change the information using [...†].
If all the information is correct, press the [ENTER] button. The programming
information is stored in a TIMER block.
6
Press [SETUP] to exit the Timer Record List.
7
Timer indicator will light or blink. You must power off the DVD Recorder+VCR
to start the Timer Recording.
• G-Code is not available in some countries.
• G-Code is a trademark applied for by Gemstar Development Corp. The
G-Code system is manufactured under license from Gemstar
Development Corporation.
42
˘ ` 42 mac001 1200DPI 90LPI
Timer Recording
Timer Recording
Manual
G-Code
Move
...†
Confirm
ENTER
Timer Recording
01/01 00:13:23
Code 1111
Media DVD
Mode SP
Repeat Once
Input Digits Confirm and Exit
0-9 ENTER
Exit timer rec
SETUP
Timer Recording
01/01 00:13:23
PR No Date Start Stop Repeat
...
PR 1 16 / 1 11 : 00 12 : 00 Once
†
Sun
Media Title Mode
DVD TITLE PR 4 SP
I
Input Digits Delete
0-9
TIMER Exit timer rec
Timer Recording
01/01 00:13:23
PR No Date Start Stop Media Repeat Mode
PR01 16/1 11:02 12:00 DVD Once SP
New Input
I
Delete Edit Exit
ENTER TIMER
§ Prev Page ∞ Next Page