Table of Contents
Advertisement
Specifications
General
Power Source
Power Consumption
Television System
Color Signal
Tape Format
Tape Speed and Recording
Fast Forward/Rewind Time
Operating Temperature
Relative Humidity
Dimensions (Jog dial included) : 16.7 (W) x 12.3 (D) x 3.7 (H) (in.)
Weight
Heads-Video
Luminance Signal
Audio Track
Audio/Control
Erase
Motors
Battery Backup
Weight and dimensions shown are approximate.
Design and specifications are subject to change without notice.
(*1)
Tape Speed and Recording Time:
T-120
Time
Mode
Mode
(hour:minute)
6H (EP)
6:00
8H (EP)
L18H (EP)
18:00
L24H (EP)
L30H (EP)
30:00
L40H (EP)
48H (EP)
54:00
64H (EP)
72H (EP)
78:00
96H (EP)
96H (EP)
102:00
128H (EP)
0H (EP)
–
0H (EP)
Note
If the VCR is not working correctly or showing an unusual indication on the fluorescent display, press RESET button at the rear panel with a pointed
instrument. When pressed, Date/Present time/ALARM LIST/POWER LOSS LIST/Counter display/Recording and Playback mode will be set to the
default setting and the VCR turns off.
To restart the VCR, press POWER button to turn on the VCR and then set the day and present time.
Reference page
: AC 100-230 V
10%, 50/60 Hz
(The included power cord is used for
120 V, 60 Hz.)
: Approx. 20 watts
: EIA standard 525 lines, 60 field NTSC-
type color system
: Low frequency conversion, sub-carrier
phase shift recording
: VHS 1/2" width high-density video
cassette tape
: See below (*1)
: Approx. 120 seconds with T-120 tape
: 41 F to 104 F (5 C to 40 C)
: Max. 80 %
425 (W) x 313 (D) x 95 (H) (mm)
: 9.7 lbs (4.4 kg)
: 4 rotary heads
: Frequency modulation recording
: 1 track
: 1 stationary head
: 1 full-track head
: 3 motors-drum/capstan direct drive
system
: Lasts 31 days
T-160
Speed
Time
(mm/s)
(hour:minute)
8:00
11.12
24:00
3.71
40:00
2.22
72:00
–
104:00
–
136:00
–
–
–
Audio
Input
Output
Signal-to-Noise Ratio
Frequency Response
Video
Input
Output
Signal-to-Noise Ratio
Horizontal Resolution
Connectors
ALM Input
: Screw terminal for starting alarm recording
RST Input
: Screw terminal for finishing alarm recording or for
REC Input
: Screw terminal for starting/finishing recording or for
GND
: Screw terminal for ground
ALM Output
: Screw terminal for output while alarm recording is
CLK Output
: Screw terminal to command camera switching
MODE Output : Screw terminal for indication of VCR selected mode
CALL Output : Screw terminal for external warning device or for
RS-232C Interface : D-SUB 9 pin connector
Recording
Recording Fields
Interval
per Second
(s/field)
(fields/s)
0.0167
60
0.050
20
0.083
12
0.150
6.7
0.217
4.6
0.284
3.5
–
–
: <Line In> 308 mV (rms), 47 k , RCA plug
<MIC In> 0.346 mV (rms), 600
: 388 mV (rms), 1 k , RCA plug
: Better than 43 dB
: 70 Hz - 4 kHz (6H mode)
: 1.0 V (p-p), 75
, BNC plug
: 1.0 V (p-p), 75
, BNC plug
: Better than 42 dB
: More than 400 lines (Super Resolution mode)
More than 240 lines (VHS mode)
adjusting on-screen clock
series recording
under way
series recording
Video Signal
Audio Signal
Continuous
Recordable
Time Lapse
Recordable
Time Lapse
Recordable
Time Lapse
Not recorded
Time Lapse
Not recorded
Time Lapse
Not recorded
Time Lapse
Not recorded
Others
, mini jack
Tape Drive
Continuous
Continuous (Slow)
Continuous (Slow)
Time Lapse
Time Lapse
Time Lapse
Time Lapse
37
Advertisement
Table of Contents
