Table of Contents
Advertisement
Warning Display
Self-diagnostic function
This VCR uses a self-diagnostic function to detect an internal malfunction during recording. When a malfunction occurs in the VCR
during recording, the indicator corresponding to each malfunction illuminates on the fluorescent display and/or on screen.
The type of malfunction corresponding to the indicator and countermeasures are given below.
Fluorescent
Monitor
display
End
TAPE END
noSI g
NO SIGNAL
(the display
CHECK
starts flashing)
When the tape ends
When the tape reaches its end during recording, "End" illuminates on the fluorescent display and "TAPE END" illuminates on screen.
The warning indicators will not illuminate, if TAPE END in FIRST TIME SET UP menu is set to REPEAT, ALARM•PROT (when no
alarm recording is made) or REWIND.
Lack of video signal input
The indicator "NO SIGNAL" appears on screen and "noSIg" flashes on the fluorescent display when the VCR cannot get any video
input signal during recording. The video input signal will not be obtained in case of any malfunction such as a broken video cable or
POWER to the camera is turned off.
Reference page
Cause
The tape ends during
recording.
Lack of video signal input
during recording
Tape/deck trouble
during recording
Remedy
Turn off the indicator on the fluorescent
Rewind the tape or
display and screen by pressing the
press the EJECT button
EJECT button or rewinding the tape.
Check for loose
connections.
First, check the cassette. If there seems to be nothing wrong with
the cassette, try the recording operation again. If the indicator
"CHECK" is still displayed on the monitor, replace the cassette with
a new one and try the operation again. If this does not clear the
indicator unplug the power cord and contact your dealer.
To turn off the indicator
When a video signal is restored or the
recording mode is cleared, the indicator
on the fluorescent display and screen
turns off.
Others
35
Advertisement
Table of Contents
