Table of Contents
Advertisement
Playback
1. Turn on the VCR and peripheral devices.
2. Load a pre-recorded tape.
3. Repeat steps 3 to 7 in Manual
Recording for activating Super
Resolution playback mode.
4. Press REC/PLAY MODE button to
select the desired playback mode.
5. Press PLAY button to start playback.
•
If noise occurs during playback,
adjust the tracking,
6. Press STOP button to stop playback.
Info.
•
VCR automatically plays back the tape of which the erase
prevention tab removed, AUTO PLAY.
•
IMPORTANT! Due to the new method for recording tapes in
super resolution mode, tapes recorded in the ADV096HD
VCR cannot be reviewed using other models of American
Dynamics VCRs.
In addition, tapes recorded on other American Dynamics
VCRs cannot be reviewed using the ADV096HD VCR.
Note
•
When TAPE LENGTH in FIRST TIME SET UP menu is set
to T-120, the playback mode is switched in the order of 6H
L18H
L30H
48H
a tape recorded in the recording mode longer than 6H
mode).
When TAPE LENGTH in FIRST TIME SET UP menu is set
to T-160, the playback mode is switched in the order of 8H
L24H
L40H
64H
(for a tape recorded in the recording mode longer than 8H
mode).
– A tape recorded in SP mode using other VCR can only
be played back in 2H mode.
•
Picture jitter or noise may occur when the tape is played
back in L18H, L24H, L30H or L40H mode even if the tape
was recorded in its respective mode.
•
When a pre-recorded tape is used for recording, the colored
noise may appear on the beginning of the playback picture.
•
There is normal sound playback only when a tape recorded in
6H, 8H, L18H, L24H, L30H or L40H mode is played back in
its respective mode.
page 16-17 to find a picture you wish to view.
8
Basic Functions
page 17.
72H
96H
0H
6H... (for
96H
128H
0H
8H...
When the tape reaches its end during playback/fast
forwarding
VCR's function varies by the setting of TAPE END in the FIRST
TIME SET UP menu.
VCR's function
TAPE END
setting
STOP or REWIND
VCR automatically rewinds
REPEAT or
to the beginning of the tape
ALARM•PROT
and stops.
page 32 for TAPE END setting.
Rewinding a tape
While the tape is stopped, turn SHUTTLE to the left.
To stop rewinding, press STOP button.
Fast forwarding a tape
While the tape is stopped, turn SHUTTLE to the right.
To stop fast forwarding, press STOP button.
Info.
•
The fast forward/rewind time of a T-120 tape is
approximately 2 minutes, however, the time varies by the
type of a tape you use.
Audio playback and picture quality
Playback mode
2H-8H
L18H-L40H
Audio
Very
playback
good
Picture
Very
good
Quality
Note
A point to notice
Fast
Playback
Forward
Stop
Stop
Stop
48H-128H
Not
Good
available
Good
Good
Supplementary information
Info.
Advertisement
Table of Contents
