Rear Wheel - Yamaha TT-R90(W) Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle from the
right-hand side.
NOTE:
Make sure that the slot in the brake
shoe plate fits over the retainer on the
fork leg.
6
1. Slot
2. Retainer
3. Lower the front wheel so that it is
on the ground.
4. Install the washer and axle nut,
and then tighten the axle nut to the
specified torque.
EAU41691
Tightening torque:
Axle nut:
35 Nm (3.5 m·kgf, 25 ft·lbf)
5. Adjust the brake lever free play.
(See page 6-17.)
6. While applying the front brake,
push down hard on the handlebar
several times to check for proper
fork operation.
6-28

Rear wheel

To remove the rear wheel
WARNING
G It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motor-
cycle so that there is no danger
of it falling over.
1. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the cotter pin, the nut and
the bolt.
1. Brake torque rod
2. Cotter pin
3. Brake torque rod bolt and nut
4. Brake shoe plate
EAU25080
EAU41641
EWA10820