Table of Contents
Advertisement
1
OPERATING FEATURES
3-13. Free System Ringback
>
)
Thls feature is avalabe only when a telephone inter-
connect ID code
IS
selected. If a busy tone sounds
when the PTT button
IS
pressed, the transceiver enters
this mode automat~cally.
When the PTT button is released, a beep sounds for
400ms to indicate that the mode has been entered. If
the scan
IS
on, it is resumed (the
a
mark goes on.)
When any repeater becomes available, a ringing tone
s o ~ ~ n d s
and this mode ends.
The mode is terminated when the system, group,
scan,
P n ,
or AUX key is changed.
3-14. System Search
T h ~ s feature can be programmed t o automat~cally
access other programmed systems when the selected
system cannot be accessed
If an Intercept tone
1
sounds when the PTT button
IS
pressed after setting
the moae, the transcelver has entered the mode
c
If the group ID
IS
a telephone Interconnect ID, the
transcelver then attempts t o access, In
succession,
[
other systems that have a telephone tnterconnect ID in
g
the revert group locatlon If the group ID
IS
a dlspatch
ID, the transcelver attempts to access other systems
that have a dlspatch ID programmed In the revert
group locatlon
If there
IS
no system t o be accessed, an Intercept
tone sbunds, the mode
IS
termlnated, and the trans-
celver returns to the flrst system If the access
IS
suc-
cessful, the mode
IS
termlnated, and the searched sys-
t e m becomes the n e w selected system (If durrng
scannlng, the scan stops
)
3-15. Transpond
Thts feature can be programmed t o turn on and off
each group. If the ID of the group for which trans-
d
IS
enabled is received, t w o data messages (trans-
ID and turn-off code) are automatically transmitted
mmed to turn on or off for
button is pressed for the
nd feature is set, the home
r transmission, and the re-
rformed. Signaling must
3-17. Preferred System Revert
This feature is available by assigning this feature to
the AUX (Aux~liary) key The feature is used to move
the revert system/group to the fixed programmed sys-
temlgroup qu~ckly. When the AUX key
I S
pressed
during scanning, the scan stops temporarily, and the
revert systemlgroup is displayed. The scan resumes
about one second after the AUX key is released.
3-18. Alphanumeric Display Select
The systemlgroup number display and the alphanu-
meric display can be switched with the AUX key by
assigning this feature to the key. Figure 2 shows the
characters that can be displayed. These are basic char-
acters, and can be displayed in each segment. Four
digits can be displayed at the same time.
- - - -
I 7
7 1 -
I l l
I
I
I I ,
1-1
h
I
I I I-- 1 - ! - - I 1 - 1
A B C D E F G H I
J K L M N O P Q R
S T U V W X Y Z
-
;
Fig.
2
Hide quick links:
Advertisement
Table of Contents
