Enhancing your system
The connection lead is not included. Purchase a
commercially available lead as shown below.
Portable audio
player, etc.
Listening to the playback sounds of
■
portable audio player, etc.
1
Use a connection lead to connect the portable audio
player etc. to the AUDIO IN socket.
2
Press the ON/STAND-BY button to turn the power
on.
3
Press the AUDIO IN button on the remote control or
FUNCTION button repeatedly on main unit to select
AUDIO IN function.
4
Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, lower the volume of the
connected device. If volume level is too low, increase
the volume of the connected device.
Note:
To prevent noise interference, place the unit away from
the television.
Audio cable
(not supplied)
Troubleshooting chart
Many potential problems can be resolved by the owner
without calling a service technician. If something is wrong
with this product, check the following before calling your
authorized SHARP dealer or service center.
General
■
Symptom
When a button is
●
pressed, the unit
does not respond.
No
sound
●
heard.
CD player
■
Symptom
Playback
does
●
not start.
Playback
stops
●
in the middle or
is not performed
properly.
Playback sounds
●
are skipped, or
stopped in the
middle of a track.
Remote control
■
Symptom
The
remote
●
control does not
operate.
Tuner
■
Symptom
The radio makes
●
unusual
noises
continuously.
E-11
Possible cause
Set the unit to the power
●
stand-by mode and then
turn it back on.
If the unit still malfunctions,
●
reset it. (Refer page 12)
is
Is the volume level set to
●
minimum "L-00"?
Are
the
speaker
●
disconnected?
Possible cause
Is the disc loaded upside
●
down?
Does the disc satisfy the
●
standards?
Is the disc distorted or
●
scratched?
Is the unit located near
●
excessive vibrations?
Is the disc very dirty?
●
Has condensation formed
●
inside the unit?
Possible cause
Is the AC power lead of the
●
unit plugged in?
Is
the
battery
●
correct?
Is the battery dead?
●
Is the distance or angle
●
incorrect?
Does the remote control
●
sensor receive strong light?
Possible cause
Is the unit placed near the TV
●
or computer?
Is the FM aerial placed
●
properly?
Move the aerial away from
the AC power lead if it is
located nearby.
wires
polarity