Advertisement
Available languages
Available languages
Wiring
WARNING! Only connect the unit to a 12-volt power supply with proper grounding.
Complete wiring as illustrated in the wiring diagram. Once the wiring is complete, reconnect the battery negative
terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch.
NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging the radio. The VME 9415
uses one 15 amp fuse, located in the black filter box in-line with the main wire harness.
Final Installation
After completing the wiring connections,
turn the unit on to confirm operation
(ignition switch must be on). If unit does
not operate, recheck all wiring until the
problem is corrected. Once proper operation
is achieved, turn off the ignition switch and
proceed with final mounting of the chassis.
1. Connect the wiring adapter to the
existing wiring harness.
2. Connect the antenna lead.
3. Carefully slide the radio into the
mounting sleeve, making sure it is right-
side-up.
4. Attach one end of the perforated support
strap (supplied) to the screw stud, which
is screwed into the threaded insert on
the back of the unit, using the hex nut
provided. Fasten the other end of the
perforated strap to a secure part of
the dashboard either above or below
the radio using the screw and hex nut
provided. Bend the strap to position it as
necessary.
5. Replace any items you removed from the
dashboard.
ISo-dIN Installation
1. Remove the sleeve.
2. Remove the trim ring.
3. Mount the factory brackets on the new
radio using the existing screws from the
old radio.
4. Slide the radio chassis into the dash
opening and secure.
5. Re-install the dash panel.
EJE
CT
A /
V
INPU
T
CAUTIoN! The rear of the radio must be supported with
the strap to prevent damage to the dashboard from
the weight of the radio or improper operation due to
vibration.
NoTE: For proper operation of the Cd/dVd player, the
chassis must be mounted within 20° of horizontal. Make
sure the unit is mounted within this limitation.
6
Advertisement
