Adapter Plugs; Extension Cords; Grounding Instructions - GE Spacemaker JVM141J Use And Care Manual

Geappliances microwave oven use and care guide jvm141j
Table of Contents

Advertisement

To replace combination cooktop
light/night light, first disconnect
power at main fuse or circuit
breaker panel or pull plug.
Remove screw on right side of light
compartment cover and lower cover
until it stops.
Be sure bulbs to be replaced are
cool before removing. Break the
adhesive seal by gently unscrewing
the bulbs. Replace with 40-watt
incandescent bulbs (WB02X4253)
available from your GE supplier.
High intensity 40-watt bulbs
supermarkets and hardware stores,
may also be used for replacements.
Raise light compartment cover and
replace screw. Connect electrical
power to microwave oven.
Oven Light
To replace your oven light, first
disconnect power at main fuse
or circuit breaker panel or pull
plug. Remove the top grill by
taking out the 2 screws that hold
it in place.
Next, remove the single screw
located above door near center of
oven that secures light housing.
Replace burned-out bulb with a
30-watt GE bulb (WB02X4235),
available from your GE supplier.
Clean off the grease and dust on
hood surfaces-often. Use a solution
of warm water and detergent. About
1 tablespoon of ammonia maybe
added to the water. Take care not
to touch the filters and enamel
surfaces with this solution;
ammonia will darken metal.
21
GROUNDING
INSTRUCTIONS
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an outlet
that is properly installed and
grounded. (Fig. 1)
use of
the grounding plug can result
in a risk of electric shock
INSURE PROPER
GROUND EXISTS
BEFORE USE
Consult a qualified electrician or
service technician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
Where a standard two-prong wall
receptacle is encountered, it is
your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.
Do not under any circumstance
cut or remove the third (ground)
prong from the power cord.
Do not use an adapter plug with
this appliance.
Do not use an extension cord
with this appliance.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents