Oven Light - GE Spacemaker JVM140H Use And Care Manual

Clean off the grease and dust on
hood surfaces often. Use a warm
detergent solution. About 1
tablespoon of ammonia maybe
added to the water. Take care not
to touch the filters and enameled
surfaces with this. Ammonia will
tend to darken metal.
REMOVE SCREW
To replace combination cooktop
light/night light, first disconnect
power at main fuse or circuit
breaker panel or pull plug.
Remove screw on right side of
light compartment cover and
lower cover until it stops.
I
Be sure bulbs to be replaced are
cool before removing. Break the
adhesive seal by gently unscrewing
the bulbs. Replace with 40-watt
incandescent bulbs (WB2X4253)
available from your GE supplier.
High intensity 40-watt bulbs
supermarkets and hardware stores
may also be used for replacements.
Raise light compartment cover and
replace screw. Connect electrical
power to microwave oven.
17

Oven Light

To replace your oven light, first
disconnect power at main fuse
or circuit breaker or pull plug.
Remove the top grill by taking off
3 screws which hold it in place.
Next, remove the single screw
located above door near center
of oven that secures light housing.
Replace burned-out bulb with
30-watt incandescent bulb
GE supplier. Secure light housing
with screw.