Daewoo FR-860NA Installation Instructions Manual

1. Installation Instructions

Suitable Installation Place

Where the floor is solid and level
• Unstable installation causes vibration and
noise of refrigerator.
• Wooden floor or carpet can be discolored
under the refrigerator.
• Doors look hanged down due to the twist
of refrigerator unless it is levelled.

Grounding

Grounding terminal is the green one connected to the power cord in the back of refrigerator.
Grounding is necessary
where
Grounding by using
grounding wire
Grounding by using
short-circuit breaker
Grounding is not necessary
You should not connect the
ground wire to

Correct usage of Refrigerator

Plug in the refrigerator
* See page
after installation. details.
Set both compartments' * When the surrounding
temperature to "3" to
temperature is hot in
perform preparatory run midsummer, do not
for 2 or 3 hours.
open and shut the doors
When the inside is cold too often after
enough, put the foods in.
installation.
Where ventilation is good
• More than 10 cm from 3 sides (left, right
and back) is good enough for ventilation.
• Insufficient space causes the noise of
vibration, weakening of refrigerating
power and the waste of electricity.
water can splash easily ; there is much moisture ;
Kitchen etc. basement etc.
Bury copper plate to which grounding wire is connected 25 cm deep in the ground.
Short-circuit breaker is a must where the floor is always wet, for example, fish shop,
restaurant kitchen etc.
in case of using side-grounded outlet.
water pipe, gas pipe, telephone line,
lightening-rod.
There can be an explosion or fire.

Installation Process

Attatch the height adjustable legs to their holes in the
for
2
left and right bottom of refrigerator.
Adjust the height by turning the legs until they touch the floor.
• Let the right adjustable leg touch the floor firmly, while the
left, smoothly.
Where there is little or no heat, moisture
• Direct sun light, side heat of stove and gas
range can weaken the refrigerating power.
• Avoide a place by the faucet or sink with much
moisture and where water can splash. Rust and
corrosion, short-circuit are surely made.
• Use hard board or a plank on a
concrete/cement floor.
any wet and/or damp
places.
Side
Grounded
outlet
Grounding wire
1