How To Wash - Daewoo DW-6510 Instruction Manual

DW-6510(¿ )-Dema 01.3.26 9:21 PM ˘ ` 3
Connection of Hoses
• Attach the water intake hose to the water inlet located at
the control panel. Press fit the other end of the hose to
either a hot or cold water tap as required.
Caution: This unit is made of poly propylene, use water
below 50 C
• Attach the drain hose to the drain outlet at the rear of the base.
• The drain hose should be laid flat on the ground. Water flow will be restricted if any portion of the drain
hose is raised from the ground. (NON PUMP)
• Hang up the drain hose on the edge of a sink. (PUMP)
Caution: The opening must not be obstructed by carpeting when the washing machine is installed on a
carpeted floor.
(NON PUMP)

HOW TO WASH

Preparation
• Sort the clothes into groups-whites, colorfast, non-colorfast, delicates, lint free, lint producer, etc., and
wash according to the LAUNDRY GUIDE.
• Clothes with worn patches or tears should first be mended. Empty out all pockets and close all side
fasteners. Treat bad stains prior to washing.
• Ensure the drain hose is in its correct position. (See INSTALLATION)
• Inlet power cord plug into the power point and switch on.
How to Wash
1Set the wash timer knob to position "0".
Set the Valve selector to the "WASH · RINSE" or "OFF" position. (PUMP)
Set the Valve selector to the "STRONG" or "NORMAL" position. (NON-PUMP)
2Set the water guide knob to "WASH".
3Open the water faucet and feed water to the water level indicated inside wash tub.
4 Put detergent and launday into the wash tub.
5Set wash time with the wash timer.
6When washing is finished, set the Valve selector to the "DRAIN" position and drain the wash tub.
Drain hose
Less than 10cm
3
(PUMP)
Drain Outlet
A