Using The Ip Address For Remote Switch Management; Starting A Telnet Session; Starting A Web Browser Session - HP ProCurve 6120G/XG Installation And Getting Started Manual

Using the IP Address for Remote Switch
Management
The switch's IP address can be used to manage the switch from any PC on the same subnet as
the switch. Either a Telnet session or a standard web browser can be used to manage the switch.

Starting a Telnet Session

To access the switch through a Telnet session, follow these steps:
1. Make sure the switch is configured with an IP address and that the switch is reachable
from the PC that is running the Telnet session (for example, by using a Ping command to
the switch's IP address).
2. Start the Telnet program on a PC that is on the same subnet as the switch and connect to
the switch's IP address.
3. You will see the copyright page and the message "Press any key to continue". Press a key,
and you will then see the switch console command (CLI) prompt, for example:
ProCurve Switch 6120G/XG#
Enter help or ? to see a list of commands that can be executed at the prompt. Entering
any command followed by help provides more detailed context help information about
the command. Entering any command followed by ? displays a list of options that are
available at that point in the command entry.

Starting a Web Browser Session

The Blade Switch can be managed through a graphical interface that you can access from any
PC or workstation on the network by running your web browser and typing in the switch's IP
address as the URL. No additional software installation is required to make this interface
available; it is included in the switch's onboard software. The Web browser can be accessed
through both the inband IP management, and through the out-of-band IP address.

Using the IP Address for Remote Switch Management

21