HP ProCurve Switch 6120G/XG Management Manual page 95

ProCurve (config)# show gvrp
GVRP support
Maximum VLANs to support [8] : 8
Primary VLAN : DEFAULT_VLAN
GVRP Enabled [No] : No
Figure 3-6. Example of "Show GVRP" Listing with GVRP Disabled
ProCurve (config)# show gvrp
GVRP support
Maximum VLANs to support [8] : 8
Primary VLAN : DEFAULT_VLAN
GVRP Enabled [No] : Yes
Port Type | Unknown VLAN
---- --------- + ------------
D1 1000X | Block
D2 1000X | Block
D3 1000X | Disable
D4 1000X | Disable
. . | .
. . | .
. . | .
X2 | Learn
C1 10GbE-CX4 | Learn
Figure 3-7. Example of Show GVRP Listing with GVRP Enabled
Enabling and Disabling GVRP on the Switch. This command enables
GVRP on the switch.
Syntax: gvrp
This example enables GVRP:
ProCurve(config)# gvrp
This example disables GVRP operation on the switch:
ProCurve(config)# no gvrp
Enabling and Disabling GVRP On Individual Ports. When GVRP is
enabled on the switch, use the unknown-vlans command to change the
Unknown VLAN field for one or more ports. You can use this command at
either the Manager level or the interface context level for the desired port(s).
Configuring GVRP On a Switch
This example includes
non-default settings for
the Unknown VLAN field
for some ports.
GVRP
3-15