HP ProCurve Switch 6120G/XG Management Manual page 57

Static Virtual LANs (VLANs)
Configuring VLANs
Note that you can
execute these
three steps at
another time.
2-34
For example, to reconfigure the switch to allow 10 VLANs:
Figure 2-23. Example of Command Sequence for Changing the Number of VLANs
Changing the Primary VLAN. In the default VLAN configuration, the port-
based default VLAN (
DEFAULT_VLAN
reassign the Primary VLAN to any port-based, static VLAN on the switch. (For
more on the Primary VLAN, refer to "The Primary VLAN" on page 2-45.) To
identify the current Primary VLAN and list the available VLANs and their
respective VIDs, use show vlans.
Syntax: primary-vlan
<
Reassigns the Primary VLAN function. Re-assignment must be
to an existing, port-based, static VLAN. (The switch will not
reassign the Primary VLAN function to a protocol VLAN.) If you
re-assign the Primary VLAN to a non-default VLAN, you cannot
later delete that VLAN from the switch until you again re-assign
the Primary VLAN to another port-based, static VLAN.
For example, if you wanted to reassign the Primary VLAN to VLAN 22 and
rename the VLAN with "22-Primary" and display the result:
Figure 2-24. Example of Reassigning Primary VLAN and Changing the VLAN Name
) is the Primary VLAN. However, you can
vid | ascii-name-string
>
Reassigns the
Primary VLAN to
VLAN 22.
Renames VLAN 22 to
"22-Primary".