Connecting Other Equipment - Sharp GX-M10H(OR) Operation Manual

Connecting other equipment

The connection lead is not included. Purchase a commercially
available lead as shown below.
Connecting a guitar / microphone
Caution:
Be careful not to connect a bass guitar as it might damage this
unit.
Microphone or guitar
(not supplied)
Ø 6.3 mm monoaural
cable (not supplied)
1 Set the guitar/microphone volume (GAIN) knob to the minimum
level.
2 Connect a guitar/microphone to the correct input socket. Make
sure that the cable has a 6.3 mm (1/4") diameter plug.
3 Arrange the guitar/microphone cables into the grooves of the
cable holder on the left or the right side of the unit.
Then, thread the cable through the bottom of the unit.
Do not let the cables to be on top of the unit when using
guitar/microphone as it may cause the unit to roll over
causing damage and injury.
Thread the cables under the unit
Cable holder
4 Connect the cables to a guitar/microphone.
5 Select a source.
To mix a guitar or microphone sound with a source sound,
select the playback source (iPod/CD/USB/Audio In/Tuner).
To play a guitar or using the microphone only, select 'AUDIO
IN' function. Make sure there is no playback from Audio In
connection.
6 Adjust the volume (GAIN) knob on the connected equipment.
Note:
Before disconnecting the guitar/microphone, set the guitar/
microphone volume (GAIN) knob to the minimum level.
Listening to the playback sounds of
portable audio player, etc.
Headphone (not
supplied)
1 Use a connection lead to connect the portable audio player etc.
to the AUDIO IN socket. When using video equipment, connect
the audio output to this unit and the video output to a television.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the AUDIO IN button on the remote control or TUNER/
AUDIO IN button repeatedly on the main unit to select AUDIO
IN function.
4 Play the connected equipment. If volume level of the connected
device is too high, sound distortion may occur. Should this
happen, lower the volume of the connected device. If volume
level is too low, increase the volume of the connected device.
Note:
To prevent noise interference, place the unit away from the
television.
Headphones
Do not turn the volume on to full at switch on and listen to music
at moderate levels. Excessive sound pressure from earphones
and headphones can cause hearing loss.
Before plugging in or unplugging the headphone, reduce the
volume.
Be sure your headphone has a 3.5 mm (1/8") diameter plug
and impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
Plugging in the headphone disconnects the speakers
automatically. Adjust the volume using the VOLUME control.
18
Portable audio
player, etc.
Audio cable (not supplied)