Listening To The Radio; Using The Radio Data System (Rds) - Sharp GX-M10H(OR) Operation Manual

Listening to the radio (continued)
Memorising a station
You can store 40 FM stations in memory and recall them at the
push of a button. (Preset tuning)
1 Perform steps 1 - 3 in "Tuning".
2 Press the MEMORY button.
3 Within 30 seconds, press the PRESET ( or ) button to select
the preset channel number. Store the stations in memory, in
order, starting with preset channel 1.
4 Within 30 seconds, press the MEMORY button to store that
station in memory. If the "MEM" indicator and preset number
disappear before the station is memorised, repeat the operation
from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a preset
station. When a new station is stored in the memory, the station
previously memorised for that preset channel number will be
erased.
Note:
The backup function protects the memorised stations for a few
days should there be a power failure or the AC power lead become
disconnected.
To recall a memorised station
1 Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
To scan the preset stations
The stations saved in the memory can be scanned automatically.
(Preset memory scan)
1 Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will fl ash and the programmed stations will
be tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or
station is located.
To erase entire preset memory
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Whilst pressing down the PRESET
STAND-BY button until "TUNCLEAR" appears.
) button again when the desired
button, press the ON/

Using the Radio Data System (RDS)

RDS is a broadcasting service which a growing number of FM
stations provide. These FM stations send additional signals
along with their regular programme signals. They send their
station names, and information about the type of programme
such as sport, music, etc.
When tuned to an RDS station, "RDS" and the station name will
be displayed.
"TP" (Traffi c Programme) will appear on the display when the
received broadcast carries traffi c information, and "TA" (Traffi c
Announcement) will appear whilst a traffi c information is on air.
"PTYI" (Dynamic PTY Indicator) will appear whilst the Dynamic
PTY station is received.
You can control the RDS by using the buttons on the remote
control only.
Information provided by RDS
Each time the RDS DISP button is pressed, the display will
switch as follows:
Station name (PS)
Frequency
When tuning in to a station other than an RDS station or to an
RDS station which sends weak signal, the display will change in
the following order:
NO PS
98.80 MHz
15
Programme type (PTY)
Radio text (RT)
NO PTY
NO RT