Regulation & Safety Notices; Fcc Notice; Notice; Caution - Mimio MimioProjector User Manual

Technical and Environmental Information
Do not do the following
n
n
n
n
Regulation & Safety Notices
This section lists the general notices of your projector.

FCC Notice

This device has been tested and found to comply with the limits for a Class B digital device
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This device generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this device does cause harmful interference to radio or television reception, which can be
determined by turning the device off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
n
n
n
n

Notice

Shielded cables All connections to other computing devices must be made using shielded
cables to maintain compliance with FCC regulations.

Caution

Changes or modifications not expressly approved by the manufacturer could void the user's
authority, which is granted by the Federal Communications Commission, to operate this
projector.
52
Clean the lens.
Block the ventilation slots and openings on the unit.
Use abrasive cleaners, waxes, or solvents to clean the unit.
Use under the following conditions:
In extremely hot, cold, or humid environments.
l
Ensure that the ambient room temperature is between 5°C - 40°C.
l
Ensure relative humidity is a maximum of 80%, non-condensing.
l
In areas susceptible to excessive dust and dirt.
l
Near any appliance generating a strong magnetic field.
l
In direct sunlight.
l
Reorient or relocate the receiving antenna.
Increase the separation between the device and receiver.
Connect the device into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/television technician for help.