Asus CUV4X-ME User Manual page 34

3. HARDWARE SETUP
10) Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After connect-
ing the single end to the board, connect the two plugs on the other end to the
floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-
tion when using ribbon cables with pin 5 plugged).
®
CUV4X-ME
CUV4X-ME Floppy Disk Drive Connector
11) Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output, such as
the ASUS PCI-L101 Ethernet card (see 7. Appendix). The connector powers up
the system when a wakeup packet or signal is received through the LAN card.
IMPORTANT: This feature requires that Wake-On-LAN features are enabled
(see 4.4.3 Power Management) and that your system has an ATX power supply
with at least 720mA +5V standby power.
®
CUV4X-ME
CUV4X-ME Wake-On-LAN Connector
34
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power.
+5 Volt Standby PME
ASUS CUV4X-ME User's Manual
NOTE: Orient the red markings on
the floppy ribbon cable to
PIN 1
PIN 1
WOL_CON
Ground