Contents 1 Important Safety Notice 2 Your car stereo speakers Introduction What’s in the box 3 Installation Mount the woofer Mount the Tweeter Mount the network Connect the woofer/tweeter to the network 4 Product information 5 Troubleshooting...
Tweeter (with wire) (x2) d Network (x2) Congratulations on your purchase, and e Speaker wire (x4) welcome to Philips! To fully benefit from the support that Philips offers, register your product f Angle adapter (x2) at www.philips.com/welcome. g Fix frame (x2)
3 Installation Turn off the car ignition key. • If the power is on, the click noise generated by the connection may damage the speakers. A depth of at least 52mm is required to mount Cut out the mounting template from the the woofer and a depth of at least 19mm is packing box and paste it on the location required to mount the tweeter.
Follow the steps in section “Option 1: Mount Mount on the speaker as shown below. in door” to mount the speakers into the rear tray. Mount the Tweeter Follow steps mentioned in “Mount the woofer” section to mount the tweeters. Option 1: Flush mounting Press and insert the edges of the grille net.
Connect the woofer/tweeter to the network Note • Match the “left”, “right”, “+” and “-” terminals correctly. Revised polarity may degrade sound quality. • Two 4-ohm speakers, wired in stereo, present a 8 ohm load to each channel of the amplifier. Most two channel amplifiers work well in this configuration.
4 Product information Note • Product information is subject to change without prior notice. Model CSP550 CSP650 CSP652 Speaker type 13cm, 2-way 16.5cm, 2-way 16.5cm, 2-way component speaker component speaker component speaker RMS power (Watts) Peak music power (Watts) 210W...
To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, go to the Philips web site (www.philips.com/ welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.