Table of Contents
Advertisement
2.3.1.
Setup
2.3.1.1.
Basic Configuration
Setup Assistant
The setup assistant provides a step-by-step interface for basic router
configuration. This configures most common settings automatically.
WAN Setup
Here you'll find the most important settings to configure your
internet access and WAN port. DHCP is enabled by default, but you can
also use PPPoE, PPTP, L2TP, static IP, or HeartBeat Signal. If you
don't use a password to log in to your ISP, you may need to enter
"0000" for the password. Also, for some ISPs you should not enter the
service name, as it will prevent establishing the connection. If you
experience connection problems, then leave the service name empty.
WAN Connection Type
Disabled
Static IP
Automatic
Configuration - DHCP
PPPoE
PPTP
L2TP
HeartBeat Signal
3G/UMTS
Network Setup
Network Setup configures the router's basic settings to match the
local network. By default these settings are valid for all network
ports except the WAN because they are all attached to the default
bridge. If ports are disassociated from the bridge they will have
different settings.
2.3.1.2.
Dynamic DNS (DynDNS or DDNS)
Dynamic DNS allows the assignment of a DNS record to a dynamically
assigned WAN-side IP address. A DynDNS client updates DNS records when
your WAN-side IP address changes.
Description
The WAN port is disabled.
A static IP address will be used – enter the
IP address, subnet mask, gateway, and server
manually.
The router obtains its WAN-side IP address
from a DHCP server.
Configure as PPPoE-client.
the "VDSL-Tagging" box.
Establishes connection via PPTP.
Establishes connection via L2TP.
If you use a HeartBeat connection, consult
your ISP for setup information.
Signal is used only in Australia.
Configures Internet Access via 3G/UMTS.
Enable USB in the "Services" section and
attach a 3g/UMTS USB stick to the router.
This setting is available in AirStations sold
in the European region only.
- 6 -
For VDSL, check
HeartBeat
Hide quick links:
Advertisement
Chapters
Table of Contents
