Memory Configuration Table - SOYO SY-5SSM User's Manual & Technical Reference

Hardware Setup
l
MEMORY CONFIGURATION
This Motherboard features 3 x DIMM Banks for 168-pin 3.3V
unbuffered DIMM modules
Your board comes with three DIMM sockets, providing support for
up to 768MB of main memory using DIMM modules from 8MB to
256MB. For 66MHz host bus CPUs use 12ns or faster DIMM
modules; for 83MHz or faster host bus CPUs use 8ns modules.

Memory configuration Table

MEMORY
CONFIGURATION
RAM Type
Single RAM
Module Size (MB)
Step 6. IDE Device Installation (HDD, CD-ROM)
This Motherboard offers two primary and secondary IDE device
connectors (IDE1, IDE2.) It can support up to four high-speed HDD
or CD-ROM drives.
Connect one side of the 40-pin flat cable to the IDE device (HDD or
CD-ROM) and plug the other end to the primary (IDE1) or secondary
(IDE2) directionally keyed IDE connector on the Motherboard.
This Motherboard can support up to four HDDs.
Note: This motherboard supports Ultra DMA 33 and Ultra
DMA66 hard drives. Ultra ATA/66 hard drive requires a special
40-pin, 80-conductor cable.
Step 7. Floppy Drive Installation
The system supports 5 possible floppy drive types: 720 KB, 1.2 MB,
1.44 MB, 2.88 MB, and LS-120. In addition, this Motherboard
supports a 3-mode (720KB/1.25MB/1.44MB) floppy commonly used
in Japan.
DIMM 1
SDRAM
8/16/32/64/128/
256
23
SY-5SSM & SY-5SSM/5 V1.1
DIMM Banks
DIMM 2
SDRAM
8/16/32/64/128/
256
DIMM 3
SDRAM
8/16/32/64/128/
256