System Power Management; Ups Settings - Buffalo LinkStation User Manual

Using your LinkStation

System Power Management

UPS Settings

A UPS (uninterruptable power supply) can automatically shut down your LinkStation in case of a
power outage. To use the LinkStation with a UPS, configure the following settings:
1
Plug the power cable of UPS to a wall socket.
2
Connect the AC adapter of the LinkStation to the UPS.
3
Connect the UPS and the LinkStation with a USB cable.
4
Turn on the UPS, then the LinkStation.
5
6
The LinkStation is now configured to work with the UPS.
Note: If the LinkStation shuts down automatically due to a power outage, make sure that the power
issue is resolved before turning it back on. If the LinkStation is turned back on while it's still
running on the UPS battery, the UPS will not shut it down again, even if the battery runs low.
LinkStation User Manual
In the LinkStation's configuration utility,
navigate to [System] - [Power Management] -
[UPS Settings] and click [Modify Settings].
1 Check [Enable].
2 Configure settings.
3 Click [Save].
57