Siemens WK14D540GB Installation And Operating Instructions Manual page 22

Detergent residues on the
washing.
Grey residues on the
washing.
Programme terminated
unexpectedly.
Spinning during drying
Drying result not
satisfactory.
The fabric softener is not
completely flushed in or too
much water remains in the
compartment i.
The laundry is not dried.
No display on the display
panel.
Door cannot be opened.
Some phosphate-free detergents
contain water-insoluble residues which
appear on washing as light specks.
Soiling caused by ointments, grease or
oil.
The Start/Pause button was selected
accidentally.
No fault
The laundry clings to the sides of the
drum after being spun.
Closed tap
Selected drying time too short.
Maximum or minimum load not taken
into account –> page 30.
The fabric softener compartment insert
is not correctly attached or is blocked.
The tap is turned off.
The load is too large.
The drying time is too short.
Power cut.
$ (Rinse hold) has been selected.
The programme is running or the door
is locked for safety reasons.
Power cut.
Rinse the laundry again or change to
using liquid detergent. Brush the
laundry after it has dried.
Wash the laundry using the maximum
detergent dosage and the maximum
permissible temperature – see the
care label.
Press the button again to restart the
programme.
"Thermo spin", which is for energy-effi-
cient drying, starts after a drying time
of approx. 10 minutes.
Loosen up the laundry by hand,
start the drying programme
–> page 16.
Turn on the tap.
Select the drying time according to the
load size.
Once the programme has ended:
adjust the load quantity, select a
suitable drying programme and restart.
If necessary, clean the fabric softener
compartment insert and fit it correctly
in compartment i.
Turn on the tap.
Reduce the load size.
Select a suitable drying time.
The programme continues when power
is restored. If you wish to remove the
laundry during a power cut, you must
first drain out the water –> page 19.
Check whether:
- the plug is plugged into the socket
correctly
-the circuit breaker (fuse) has tripped;
call the after-sales service. –
> page 24.
Select the programme
Empty + Spin and press Start/Pause.
Wait until appears on the
display panel.
Unlock the door mechanically.
22