Washing And Drying Options - Siemens WK14D540GB Installation And Operating Instructions Manual

Washing and drying options

Temp. button
Spin rpm button
Rinse Hold
Unbalanced load detection
system
Option button
Select button
Options (symbols on the display panel)
! Pre-wash
È Intensive
Q Easy-iron
R Water plus
A Flexi Time
C Signal
Delay Start button
The temperature can be adjusted individually for each programme.
To adjust it, press the Temp. button repeatedly until the required
temperature is displayed.
The spin speed can be individually adjusted for each programme.
To set the spin speed, press the Spin rpm button repeatedly until the
required spin speed is displayed.
$ (Rinse hold) deactivates the spin function. The laundry remains in the
rinsing water.
The automatic unbalanced load detection system ensures that the laundry
is evenly distributed using several initial spins. If the laundry is extremely
unevenly distributed, the speed of the final spin is reduced or the spin
cycle is not performed for safety reasons.
The set programmes can be individually adjusted.
To choose the required option:
 Press the Option button repeatedly until the required option is selected
(indicator lamp flashes).
 Press the Select button to switch the option on/off (indicator lamp
lights up/does not light up).
i
If you press and hold the Option button, all the options scroll through.
Prewash at 35 °C. Suitable for heavily soiled laundry.
Washing time lengthened at 60 °C. Suitable for delicate, soiled
laundry. Cannot be combined with A Flexi Time
Special spin sequence with subsequent fluffing. Gentle final spin at
reduced speed. Slightly increased residual moisture in the laundry.
Reduces creasing and laundry is easier to iron.
Increased water level and additional rinse cycle. For regions with very soft
water or for further improving the rinsing result. Any detergent residues
are removed.
Sets the washing time, normal-medium-short.
Activates or deactivates the audible signal.
You can postpone the Programme start before it begins. Using the
Remaining time, you can determine when the selected programme is to
end. The remaining time can be set in one-hour increments, up to a
maximum of 24 hours. Press the Delay Start button repeatedly until the
required number of hours is displayed.
Then press the Start/Pause button, the programme will start after a delay
according to the set (Finished in time). The required time to the end of the
programme is shown on the display panel.
14