Table of Contents
Advertisement
en
Condensation outlet fascia
To clean the condensation outlet
channel, the glass shelf above the
vegetable drawer, Fig. 1/7, must be
separated from the condensation outlet
fascia.
Take out the glass shelf, lift condensation
outlet fascia and take out. Fig. .
Regularly clean the condensation
channel and drainage hole with a cotton
bud or similar implement to ensure
that the condensation can drain.
Removing the container
Pull out the container all the way, lift at
the front and remove. Fig. 5
Vegetable drawer
(not all models)
The fascia of the vegetable drawer can
be removed for cleaning.
Press side buttons in succession
and remove fascia from the vegetable
drawer. Fig. /
Take out shelves in the door
Lift shelves upwards and take out. Fig. 9
Odours
If you experience unpleasant odours:
1. Switch off the appliance with the On/
Off button. Fig. 2/1
2. Take all food out of the appliance.
3. Clean the interior. See "Cleaning
the appliance".
4. Clean all packages.
5. Seal strong smelling food in order to
avoid odours from forming.
6. Switch on the appliance again.
7. Store food in the appliance.
14
8. Check whether the formation of
odours is still occuring after 24 hous.
Light (LED)
Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.
Tips for saving energy
Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool
■
down before placing in the appliance!
When thawing frozen products, place
■
them in the refrigerator. Use
the coldness of the frozen food
to cool food.
Regularly defrost the freezer
■
compartment to remove the layer of
frost!
A layer of hoarfrost will impair
refrigeration of the frozen food
and increase power consumption.
Open the appliance as briefly
■
as possible.
Occasionally clean
■
the rear of the appliance
with a vacuum cleaner or paint brush
to prevent an increased power
consumption.
There must be a gap of 60 mm from
■
the back wall so that the heated air
can escape without obstruction.
Hide quick links:
Advertisement
Table of Contents
