Adjust Doors - Jenn-Air SIDE BY SIDE BUILT-IN Installation Manual

Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up, then pull straight out. Place the top grille
panel-side down on a soft working surface.
B
A. Top grille
B. Cabinet side trim
3. Remove one end cap by loosening the nuts and sliding off the
end cap.
A. Bottom rail
B. Nuts
4. Slide the backer panel into the top grille channel and reattach
the end cap.
A. Backer panel
5. Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
B
A. Top grille
B. Cabinet side trim

Adjust Doors

Door Height Adjustment
Use the following steps to adjust the door height, up or down,
after the doors have been leveled.
1. Open the freezer or refrigerator door. Locate the bottom hinge
and remove the door stop screw.
A B
C. End cap
D. Top rail
A B
Euro-Style and Pro-Style
Remove the door stop screw from the bottom side of the
hinge with a " open end wrench.
A
A. Bushing
B. Door stop screw
C. Locking plate
Overlay Style
Remove the two door stop screws: one from the bottom side
using a " open end wrench and one from the top side using
a " hex key.
A
A. Door stop screw from bottom
B. Door stop screw from top (110°)
2. Remove the locking plate as shown.
3. Turn the bushing located underneath the bottom of the hinge
using a " open end wrench. Turning the bushing to the left
will lower the door. Turning the bushing right will raise the
door.
4. After adjusting, check the doors to make sure they are even at
the top and bottom. If the doors are not even, continue to turn
the bushing to adjust the door height.
5. Replace the locking plate.
6. Turn the bushing slightly to align the hinge and locking plate
screw holes.
7. Replace the door stop screw or screws and tighten.
IMPORTANT: Do not place the door stop screw in the 130°
position on Overlay Series models unless the custom panels
have been routed on the hinge side. See "Overlay Series Door
Panel and Cabinetry Clearance."
® Styles
B C
B
21