Kenwood TK-3230 Instruction Manual page 54

i c
ncoming All
Note: To use Incoming Call Notification, you must set up a QT tone
or a DQT code {page 16}.
Incoming Call Notification is used to inform you of when a call
is being received. When activated, a tone is emitted when a
busy signal is received and the QT/ DQT signaling matches.
• The tone will sound for 15 seconds before turning off.
• While the tone sounds, you will not hear any audio from the
speaker. Press any key to turn the tone off and listen to the
received call.
After the call is finished, the transceiver will wait for 10 seconds
before resetting. If you receive a new call within those 10
seconds, the tone will not sound. If no call is received within
10 seconds, Incoming Call Notification will reset so that the
next time a call is received, the tone will sound again.
To turn Incoming Call Notification on or off:
 With the transceiver power OFF, press and hold the MENU
key while turning the transceiver power ON (for 1 second).
 Press the
 Press the MENU key then press
(incoming call notification off), or "
notification on).
 Press the MENU key to exit the selection.
 Press the PTT, MON, or CAL key to exit Setting Mode.
n
otificAtion
or key to select " ".
or to select "
" (incoming call
"