Toshiba L73** Digital series User Manual page 17

When Encryption is WEP, Key ID setting is
B
available. Press
c B b
and / to select 1 (default), 2, 3 or 4.
B b
Press / to highlight Done and press OK.
When the message "Wireless configuration is
complete." appears on screen, press OK.
NOTE: Settings are not saved if BACK is pressed
before Done is selected.
m
The Advanced Network Setup screen will
appear.
When the DHCP function of the router connected
with this TV is On, you can set Auto Setup to On
or Off. (This should usually be set to On.)
When the DHCP function of the router is Off, set
Auto Setup to Off, and set the IP Address DNS
address(es) manually.
Quick Setup Advanced Network Setup
Country
Auto Setup
Location
IP Address
Subnet Mask
Network
Default Gateway
Auto Setup
Smart TV
Primary DNS Address
Channel Tuning Secondary DNS Address
Previous
You can view the fixed MAC address for the TV, if
one is installed.
B b
Press / to highlight Next.
n
Press OK, and Network Connection Test will start.
A message will appear to indicate if the connection
was successful or if could not be completed.
Network Connection Test
Network connection was completed successfully.
OK
NOTE: The result of Network Connection Test
does not always guarantee the connection.
To cancel the Network Connection Test:
Press EXIT while testing.
When the network can be accessed, Software
Upgrade starts automatically. When Software
Upgrade is completed, proceed to the next step.
b
/ to select Key ID and press
3/5
On
xxx xxx xx x . . .
xxx xxx xx x . . .
xxx xxx xx x . . .
On
xxx xxx xx x . . .
. . .
xxx xxx xx x
Next
5/5
o
Press OK, and TV Power On Control screen will
appear. Select Disabled or Enabled and highlight
Next.
Quick Setup
Country
Location
Network
Smart TV
Channel Tuning
p
Press OK, and Companion Device screen will
appear. Select On or Off from Enable Control and
Media Renderer and highlight Next.
q
Press OK. If the Ant/Cable/Satellite screen
appears, press
Satellite, and then press OK to check (
Antenna
Cable
Satellite
Previous
If DVB-C is not supported in your area, Cable will
not be displayed.
• When you select Antenna or Cable, follow step
18 to 21.
• When you select Satellite, skip to step 22.
• When you select Antenna (or Cable) and
Satellite, the Satellite Settings startup screen
will appear automatically after completing the
Antenna (or Cable) scan and pressing OK.
r
BbC c
Press
The Auto Tuning start up screen will appear with
the option to select between DTV and ATV, DTV
or ATV if available. Press
the appropriate mode and press OK.
17
SETTING UP YOUR TV
TV Power On Control 1/2
We recommend you Enable TV Power On
Control for quick access to Toshiba
services. Once enabled you will be able to
view Internet and Menu systems faster.
This mode will result in your TV using
higher power consumption than when
Disabled.
TV Power On Control Disabled
Previous Next
B b
/ to select Antenna, Cable or
Next
to highlight Next and press OK.
c B b
and / to select
Disabled
Enabled
).