LG AN215 Owner's Manual page 39

Replacing the Lamp
Turn off the projector and unplug the power cable.
Carefully place the lens side down on a
1
cushioned surface that will protect the lens
from damage.
(Allow the lamp to cool for 1 hour before
replacing it.)
After lifting the lamp cover off, remove the two
3 retaining screws on the lamp case with a screw-
driver or similar objects.
5
Pull out the handle slowly and remove the lamp
case.
7
Tighten the screws you removed in step 3.
(Make sure it is fixed hardly.)
Using and other lamp may cause damage to the projector or lamp.
Make sure the lamp cover is securely fastened. If the lamp cover is open, and the projector is not turned on.
In this case, contact your service center after checking the lamp to fix well.
Bolt
2
Unscrew the fixing bolts of the lamp cover using a
driver or a similar object.
Lamp case bolt
4
Lift up the fixed wire knob on the lamp.
Knob
6
Insert the new lamp gently into the correct position.
Make sure it is inserted correctly.
Close the lamp cover and fix it with the bolts from
8
2.
(If the lamp cover is open, the lamp indicator flashes green
and the projector is not turned on.)
Information
39