Maintenance - MULTIQUIP Mikasa MDR-9D Operation And Parts Manual

Vibratory walk-behind roller (hatz diesel)
Table of Contents

Advertisement

CHECKING ENGINE OIL LEVEL
Check the engine crankcase oil level prior to each use, or
when the fuel tank is filled. Make sure the pump is level. The
oil level must be between the two notches on the dipstick
as shown in Figure 25.
OIL DIPSTICK
ADD ENGINE OIL
Figure 25. Engine Oil Dipstick
CHANGING ENGINE OIL
Change engine oil after first 25 hours of operation. Drain and
refill engine crankcase with the correct type and amount oil
(reference Table 3) after 250 hours of operation hours or once
a week thereafter.
When draining engine crankcase oil, place oil into a suitable
container while engine is still warm. Replace the drain plug
tightly. Add oil through the filler hole.
MQ-MIKASA MDR-9D VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #0 (12/17/03) — PAGE 25
SAFE OPERATING
OIL LEVEL
MAX
MIN
MDR-9D — MAINTENANCE
CHANGING ENGINE OIL FILTER
Change the engine oil filter (Figure 26) and gasket after 250
hours of operation. To gain access to the oil filter element,
unscrew the oil filter cap and replace the oil filter element.
Make sure to tighten oil filter cap securely.
Figure 26. Oil Filter Element
CHANGING ENGINE FUEL FILTER
Replace fuel filter (Figure 27) and drain fuel tank to remove
water and sediment every 500 hours. If the purity of the fuel
being used is of lesser quality replace fuel filter more often
as needed.
Figure 27. Fuel Filter
NOTE
When re-installing fuel filter,
please note the arrows
indicating the direction of
fuel flow.

Advertisement

Table of Contents
loading

Table of Contents