NETGEAR ProSAFE SRX5308 Reference Manual page 214

ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Table 46. IPSec VPN Wizard settings for a client-to-gateway tunnel (continued)
Setting
This VPN tunnel will use the
following local WAN Interface
End Point Information
What is the Remote Identifier
Information?
What is the Local Identifier
Information?
Secure Connection Remote Accessibility
What is the remote LAN IP
Address?
What is the remote LAN
Subnet Mask?
a. Both local and remote endpoints should be defined as either FQDNs or IP addresses. A combination of
an IP address and an FQDN is not supported.
3. Click Apply to save your settings. The IPSec VPN policy is now added to the List of VPN
Policies table on the VPN Policies screen for IPv4. By default, the VPN policy is enabled.
Virtual Private Networking Using IPSec and L2TP Connections
Description
Select a WAN interface from the drop-down list to specify which local WAN
interface the VPN tunnel uses as the local endpoint.
Select the Enable RollOver? check box to enable VPN rollover, and select
a WAN interface from the drop-down list to the right of the check box to
specify the interface to which the VPN rollover should occur.
Note: If the VPN firewall is configured to function in WAN auto-rollover
mode, you can use the VPN Wizard to configure VPN rollover and do not
need to configure this manually.
a
When you select the Client radio button in the About VPN Wizard section of
the screen, the default remote FQDN (remote.com) is automatically entered.
Use the default remote FQDN, or enter another FQDN.
Note: The remote ID on the VPN firewall is the local ID on the VPN client.
It might be less confusing to configure an FQDN such as client.com as the
remote ID on the VPN firewall and then enter client.com as the local ID on
the VPN client.
When you select the Client radio button in the About VPN Wizard section of
the screen, the default local FQDN (local.com) is automatically entered. Use
the default local FQDN, or enter another FQDN.
Note: The local ID on the VPN firewall is the remote ID on the VPN client.
It might be less confusing to configure an FQDN such as router.com as the
local ID on the VPN firewall and then enter router.com as the remote ID on
the VPN client.
These fields are masked out for VPN client connections.
214