Adjusting The Air Deflector - Hitachi RAD-18NHA1 Instruction Manual

ADJUSTING THE AIR DEFLECTOR

1. NON DUCT
Adjustment of the conditioned air in the upward and downward
directions.
According to "Dehumidifying" or "Cooling" operation, the
horizontal air deflector is automatically set to the proper angle
suitable for each operation. The deflector can be swing up
and down and also set to the desired angle using the
" (AUTO SWING)" button. (If the angle of the deflector is
changed, it will not return to the auto-set position after
operations start unless the operation mode is switched.)
G If the " (AUTO SWING)" button is pressed once, the
horizontal air deflector swings up and down. If the button
is pressed again, the deflector stops in its current
position.
G Use the horizontal air deflector within the adjusting range
shown on the right.
G When the auto swing operation is performed, if the
horizontal air deflector is moved manually, the swing
range may drift. However, it will return to the original
operation range after a short time.
2. FULL DUCT • SEMI DUCT
G
As shown in the diagram, perform by holding the horizontal
air deflector.
G When adjusting the air direction, use a stepladder, etc.
G For full duct type and semi duct type, auto air deflector is
not provided.
CAUTION
!
G When operating the unit in cooling operation with the air deflector facing down and moving automatically
for a long period of time, water will condensed on the air deflector and drips down occasionally. This
will wet your furniture.
– 16 –
RESET