Installing The; Removing Collected - GE AHG30LH Owner's Manual

Usingthe dehumidifier.
Always make sure the water bucket is locked into place on the dehumidifier.
Removing Collected Water
There are 3 ways to remove collected water:
[] Use the bucket "x,_ h en the bucket is
relnoved,
the unit will shut off. Empq and replace the
bucket.
[]
Use a floor drain. The unit can also be placed
oxer a floor drain. Using a drill, make a hole
at the end of the nozzle located on the lower
left side of the bucket,
[]
Use a hose. Water can be automatically
emptied into a floor drain by attaching a
water hose (not included) to the bucket hose
nozzle. Using a drill, make a hole at the end
of the nozzle located on the lower left side of
the bucket. Attach a water hose to the bucket
nozzle. Fasten by hand only.
Drill hole:
Attach hose:
Nozzle
Hose
Drill
\
NOTE:Thenozzlecannot be fixed after puncture. Use
an ordinary garden hose cap (not included) to reclose
if necessary
NOTE:Avoid using mechanical tools to tighten the
water hose to the bucket nozzle.Thismay damagethe
threads on the nozzle.
Installing the Water Bucket
Lift the bucket and hook the slots on each side
onto the posts on the back of the dehmnidifie_:
The bucket should lock secm'elx in place.
Make sm'e the bucket is locked securely in place
by pressing down on the ui)per back edge of the
bucket. It will be firefly seated when l)roperly
installed.
Post
Water Level
The dehumidifier will turn off automatically
when the bucket is flfl], or when the bucket is
removed or not replaced in the proper position.
The bucket must be replaced in the proper position for
the dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is not in the
proper position.