On The Dehumidifier - GE AHG30LH Owner's Manual

About the controlson the dehumidifier.
Controls
0
@
jO
BUCKET
FULL
POWER
• HIGH
• LOW
POWER Pad
Press to turn the delmmidifier on and off.
HUMIDITY CONTROLPads
The lmmidiq' level can be set within a range
of 35% RH (Relative Humidity) to 70%
RH
(Relative Humidity) in 5% increments.
For drier ai_; press the • pad and set to
a lower percent ',_llue (%).
D)r damper ai_; press the • pad and set
to a higher percent wflue (%),
When you fit_t use the dehumidifier, set the
humidity control to 45% or 50%. Allow at
least 24 hou_ fi)r the dehumidifier to
achieve the humidity' level. If you still have
damper air than desired, set the humidity
level to a lower setting,
O FAN SPEEDPad
()mtrols the lira speed.
Press to set to
HIGHor LOWfim
speed.
Set the fan control to
HlGHfor
m'a_mum
moisture remowfl, X*\]_en the humidity has
been reduced and quiet operation is
preferred, set the thn control to
LOW.
O HUMIDITY LEVELDISPLAY
Displays percent humidit,_ lexel.
Its accuracy is (+/- 5%).
O BUCKETFULLLED
Indicates presence of bucket and its
fill level,
4
OtherFeatures
BUCKETFULLLight
Glows when the bucket is read)' to be emptied,
or when the btlcket is removed or not replaced
in the l)r(>per position.
Auto Shut Off
The Water I,e\'el Control Switch shuts oft the
dehumidifier when the bucket is fifll, or when
the bucket is removed or not replaced in the
proper position. _Mso, when the bucket is out
of position, the unit will beep 3 times.
Auto Defrost
X._]_en fi'ost builds up on the cooling coils,
the compressor will wcle off until the fl'ost
disappears. The lira continues to run.
Power Outage
If a I)ower outage occurred or if the unit was
unI)lugged, the unit will display its prh)r setting.
Note: If 0N is in the displa 5 the dehumidifier is
operating contintlOtlsl 5 but a specific humidity
level is not set. You will need to reset the
HUMIOIrI'CONrBOL t(> the desired level.
Auto Restart
Once power is restored after a power outage,
the unit automatically resumes operation atter
a 2 minute delay: