Installing The _V\Ater Bucket; Removing Collected; Ater Level - GE AHW30LJ Owner's Manual

Usingthe dehumidifier.
Always make sure the water bucket is locked into place on the dehumidifier.
Removing Collected Water
There are 3 ways to remove collected water'.
[]
Use the bucket. _q_en
the bucket is remoxed,
the unit will shut off. Erupt)and replace the
bucket.
[]
Use a floor drain. The unit can also be placed
oxer a floor drain. Using a ddll, make a hole
at the end of the nozzle located on the lower
left side of the bucket.
[]
Use a hose. Water can be automatically
emptied into a floor drain by attaching a
water hose (not included) to the bucket hose
nozzle. Using a (lcill, make a hole at the end
of the nozzle located on the lower lett side ot
the bucket. Attach a water hose to the bucket
nozzle. Fasten bv hand only.
Drill hole:
Attach hose:
Nozzle
Hose NN_
Drill
NOTE." T henozzlecannot be fixed after puncture. Use
an ordinary garden hose cap (notincluded) to reclose
if necessan/
NOTE:Avoid using mechanicaltools to tighten the
water hoseto the bucket nozzle.Thismay damagethe
threads on the nozzle.
Installing the Water Bucket
IJfl the bucket and hook the slots on each side
onto the posts on the back of the dehumidifie_;
The bucket should lock securely in place.
Make sure the bucket is locked securely in place
by pressing down on the ul)per back edge of the
bucket. It will be firefly seated when properly
installed.
_\ Post
Water Level
The dehumidifier will mrn off automatically
when the bucket is flfll, or when the bucket is
removed
or not replaced
in the proper position.
The bucket must be replaced in the proper position for
the dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is not in the
proper position.