Table of Contents
Advertisement
N750 Wireless Dual Band Gigabit ADSL Modem Router DGND4000
Application Example: Making a Local Web Server Public
If you host a web server on your local network, you can use port forwarding to allow web
requests from anyone on the Internet to reach your web server.
To make a local web server public:
1.
Assign your web server either a fixed IP address or a dynamic IP address using DHCP
address reservation. In this example, your wireless modem router always gives your
web server an IP address of 192.168.1.33.
2.
In the Port Forwarding/Port Triggering screen, configure the wireless modem router to
forward the HTTP service to the local address of your web server at 192.168.1.33. HTTP
(port 80) is the standard protocol for web servers.
3.
(Optional) Register a host name with a Dynamic DNS service, and configure your wireless
modem router to use the name as described in
web server from the Internet, a remote user has to know the IP address assigned by your
ISP. However, if you use a Dynamic DNS service, the remote user can reach your server by
a user-friendly Internet name, such as mynetgear.dyndns.org.
Set Up Port Triggering
Port triggering is a dynamic extension of port forwarding that is useful in these cases:
•
More than one local computer needs port forwarding for the same application (but not
simultaneously).
•
An application needs to open incoming ports that are different from the outgoing port.
When port triggering is enabled, the wireless modem router monitors outbound traffic looking
for a specified outbound "trigger" port. When the wireless modem router detects outbound
traffic on that port, it remembers the IP address of the local computer that sent the data. The
wireless modem router then temporarily opens the specified incoming port or ports, and
forwards incoming traffic on the triggered ports to the triggering computer.
Port forwarding creates a static mapping of a port number or range to a single local computer.
Port triggering dynamically opens ports to any computer that needs them and can close the
ports when they are no longer needed.
Note:
If you use applications such as multiplayer gaming, peer-to-peer
connections, real-time communications such as instant messaging,
or remote assistance (a feature in Windows XP), you should also
enable Universal Plug and Play (UPnP) according to the instructions
in
Universal Plug and Play
To set up port triggering, you need to know which inbound ports the application needs. Also,
you need to know the number of the outbound port that triggers the opening of the inbound
Dynamic DNS
on page 123.
Advanced Settings
116
on page 118. To access your
Advertisement
Table of Contents
